First, three holes will be drilled with 3/16″ bits. Install the outside keyed handle and the inside release handle.Drilling for the lock will be a two-step process. To prevent this from happening you will use the two red spacers above.The order of installation is as follows.
On single car doors there is often only one latch.The other system uses two sash chains and small S-hooks to link the inside handles and spring latches.If you have a foam-filled door with steel on both sides the metal on each side will compress when you tighten the screws that secure the outside handle to the inside handle. The cable runs from the spring latch on one side through the center and on the other side where a track bolt and nut secure the cable to the spring latch. Garage door locks are normally installed in the center of the section just above the bottom section. Here are instructions on how to install the two most common lock assemblies we sell.The more common lock assembly uses a cable to connect the to the.